However, if nlsaddr is missing from the MASTER LMID entry, tmadmin (1) is not able to run in administrator mode on remote machines; it will be limited to read-only operations.There are also procedures that help you resolve some problems you may run into when you first begin to start and shut down your WLE or BEA TUXEDO applications.
![]() See ubbconfig(5).). These variables are described in subsequent sections of this chapter. The tmloadcf(1) command converts the configuration file to binary form and writes it to the location given in the TUXCONFIG variable. If you use the - c option, check the platform data sheet for your platform in Appendix A of the BEA TUXEDO Installation Guide to judge whether you need to make some changes. If you do want to change IPC resources, check the administration guide for your platform. Use it if you are installing TUXCONFIG on a raw disk device that has not been initialized. The option is not recommended if TUXCONFIG will be stored in a regular UNIX system file. Table 4-2 is a list of files and directories needed for a networked application. It is helpful if this directory has the same path name on all nodes. Store the executables in APPDIR, or in a directory pointed to in a PATH variable in ENVFILES in the MACHINES section. Use mkfldhdr (1) to make a header file out of a field table file; use viewc (1) to compile a view file. The FML field tables and VIEW description files should be available through the environment variables FLDTBLDIR, FIELDTBLS, VIEWDIR, and VIEWFILES, or their 32-bit equivalents. See tlisten (1). The tlisten process must be started before the application is booted. You must create the device list entry for the TLOGDEVICE on each machine where a TLOG is needed. It can be done before or after TUXCONFIG has been loaded, but must be done before the system is booted. Refer to the section Step 2: Create a UDL Entry on page 16-10 for details. The value of config should match the value of the TLOGDEVICE parameter in the MACHINES section. If config is not specified, it defaults to the value of the variable FSCONFIG (which points to the applications databases). Steam for mac says you do not have enough disk space availableTo be recoverable, the TLOG should preferably be on a device that can be mirrored. Because the TLOG is too small (typically,100 pages) to warrant having a whole disk partition to itself, the expectation is that the TLOG will be stored on the same raw disk slice as the applications databases. For the WLE system and BEA TUXEDO system version 6.4 or above, this option is not required. For earlier versions of the BEA TUXEDO system (v6.3 and earlier), some network providers (TCPIP, for example) require this information. If the address has the form 0xhex-digits or xhex-digits, it must contain an even number of valid hexadecimal digits.
0 Comments
Leave a Reply. |
AuthorNathan ArchivesCategories |